Transfer Case Motor

Description
Product Specs
Buyers Guide
FAQ's
Downloads

Product Description

Building on decades of experience using reverse engineering to remanufacture automotive motors, CARDONE engineers have meticulously designed and tested our brand-new transfer case motors to match O.E. fit and performance. Each unit is load-tested to ensure the torque power specification meets industry standards. As a direct-fit O.E. replacement, CARDONE New Transfer Case Motors provide ease of installation and reliability you can count on.

Original design weaknesses are corrected to make alonger lasting part.

All replacement components are O.E. quality.

All critical components are tested to guaranteelike-new performance.

Units are computer tested, both as sub-assembliesand as complete units to ensure reliability.

Complete the Check It Fits tool and confirm all information in the Fitment Details section above to ensure you select the right part for your application.

Product & Technical

The replacement motor drive is in a different position, can I reposition before installing?

Do not operate the motor while it is off the transfer case. This can damage the motor and set an error code that must be cleared before the motor will operate again. Shift the transfer case into the position of the motor to install.

What tool can I use to manually shift the transfer case into the two-wheel drive position before I install the replacement motor?

A crescent wrench can be used for this operation.

The Service 4WD light is on and/or the 4WD is inoperative. What could cause this condition?

This may be caused by a transfer case control module calibration issue. Check for DTC's and calibration version − there may be a software update from the Original Equipment Manufacturer. If the motor attempts to shift, but sounds weak, check the front axle lock actuator. If the axle lock does not engage, the motor cannot complete its engagement.

Can I install the replacement motor if my Transfer Case motor failed in 4 Wheel Drive Low or High?

Yes, the transfer case should be manually shifted into the two-wheel drive position at the shift shaft before the installation of the replacement motor. Typically the positions are spring-loaded and can be rotated manually.

What drivetrain position is the replacement motor drive placed in?

The replacement motor drive is factory-set in the 2 wheel drive position.

Warranty Policy

Installation & Tech Checks

Core Policy

ProTech Bulletins

General

pdm:general_part_type:

Transfer Case Motor

pdm:general_product_condition:

New

Life Cycle Status:

Available to Order

pdm:general_package_contents:

Transfer Case Motor; Instruction Sheet

pdm:general_package_weight:

6.20 lb

UPC:

00884548265004

pdm:general_e_waste:

Yes

pdm:general_warranty:

Limited Lifetime

*A warranty must be returned to the parts supplier where the CARDONE product was purchased and is subject to that part store's terms & conditions. If the parts retailer offers a different warranty than the CARDONE warranty, the retailer’s policy will prevail.

Technical

Connector or Terminal Configuration:

Pin/Blade

pdm:Connector Gender:

Female

pdm:Connector Quantity:

pdm:Connector Shape:

Square

pdm:Gear of Chain Type:

Gear

pdm:Grade Type:

Performance

pdm:Mount Type:

Bolt

pdm:Mounting Hardware Included:

pdm:Mounting Hole Quantity:

pdm:Shift Operation Type:

Electronic

pdm:Sprocket Tooth Quantity:

pdm:Terminal Gender:

Male

pdm:Terminal Quantity:

pdm:Terminal Type:

pdm:Wiring Harness Included: