Description
Product
Specs
Buyers
Guide
FAQ's
Downloads
Remanufactured products only require 15-20% of the total energy and material it takes to manufacture new parts while keeping usable cores out of landfills.
CARDONE's skilled technicians and engineers can completely rebuild your part and return it to you, good as new. Learn More.
Product Description
CARDONE Remanufactured Rack & Pinions are re-engineered, built and tested to meet or exceed O.E. fit and performance. 100% new, O.E.-style o-rings and seals are installed to ensure leak-free, long-lasting performance. A final protective coating is applied and each unit is tested to guarantee a perfect fit and function.
Complete the Check It Fits tool and confirm all information in the Fitment Details section above to ensure you select the right part for your application.
Metafield Product & Technical
The steering wheel is not returning to center coming out of a turn. What could be causing this?
The geometry of the front suspension is designed to return the steering wheel to center coming out of a turn. If the steering wheel is not returning to center on its own when coming out of a turn, check the front-end alignment settings and inspect for binding steering components.I replaced the rack and now the power steering pump is whining. It never did this before! What happened?
The most likely cause of a power steering pump whine is air in the system. The steering system must be bled. This may take a few attempts depending on the design of the system.The replacement rack and pinion is installed and the steering wheel has too much play. Should I adjust the rack?
No. The rack and pinion has been adjusted at the factory. No additional adjustment is necessary. Try isolating the rack to find out where the play exists. If you hold the inner tie rod and have someone turn the wheel, does the play disappear? If so, the problem is in the front-end; if not, remove the steering knuckle and lightly install vise grips on the sector shaft and check for play. If no play exists, check steering column or steering knuckle.Are there any steps that should be done prior to alignment?
Yes, the boot clamps must be loosened to set the toe adjustment when performing a front-end alignment. Failure to loosen the clamps will twist the boots during turning maneuvers causing cracks to form on boot. Once the boot is torn, road debris and water intrusion can damage the rack end seal.Warranty Policy
Installation & Tech Checks
Core Policy
ProTech Bulletins
General
pdm:general_part_type:
Rack and Pinion Assembly
Life Cycle Status:
Available to Order
pdm:general_package_weight:
26.75 lb
UPC:
00082617808248
Technical
General
Part Type:
Rack and Pinion Assembly
Product Condition:
Remanufactured
Lifecycle Status:
Available to Order
Packaged Weight:
26.7500 lb
Warranty:
3 Year/36,000 Mile
*A warranty must be returned to the parts supplier where the CARDONE product was
purchased and is subject to that part store's terms & conditions. If the parts retailer offers a
different warranty than the CARDONE warranty, the retailer’s policy will prevail.
